Controller Configuration Procedures

To configure the controller you follow the following procedures:
============================================

1. Ensure you are in the proper mode by pressing the MODE button (above the green LED). Each time you press it the mode will increment to the next availble mode (10 modes) and will flash the number of times that your mode indicates (once for mode 1, 10 times for mode 10)

NOTE: The controller always starts out in Mode 1

2. Press the CNFG button (below the green LED).

NOTE: the LED should immediately turn on for 1 second and then turn off. It will then flash a number of times equal to the current mode. At this point if you are in the wrong mode, press CNFG again to abort.

3. Press the button you want to remap.

NOTE: THE CNFG and MODE buttons cannot be remapped.

NOTE: The LED will flash the number of times that represents the output that it is currently assigned to:

Flash# Output
1 X
2 Y
3 A
4 B
5 LB
6 RB
7 RSTK
8 LED

Table #1

4. If at this point you want to select a different button, press it now - it will flash according to the output currently set.

5. If instead you wish to save the setting (assuming you have changed it) press the MODE button. Proceed to step 8.

6. If you with to exit the configuration process, press CNFG.

7. If you wish to modify the output for this input, press the original button again.

Note: Each time you press the input button a repeated time it will cycle through to the next ouput available and flash the number of times associated with that output as noted in Table 1. Go back to step 4.

8. Now the system is expecting you to press either the MODE button again, or the CNFG button. MODE indicates you are saving it as a normal input. CNFG indicates that you are saving it as an inverted signal (if input is ON, output will be OFF and vice-versa).

NOTE: The LED will flash twice to confirm your save and then go back to step 4.