Post by Frisbone on Aug 23, 2015 13:38:19 GMT -5
Printer:
1. Order 40mm fan and parts for controller board - I ordered it from Mouser on 8/23/15 - received, waiting time to do something with it.
2. Recalibrate bed so it is level
3. Order wing nuts for bed so its easier to calibrate - ordered & received, not yet installed
ITC:
1. Get gun connected to the network again - SOLVED - (initially only partially, had to direct connect due to wireless inter-connectivity issues. but ultimately I realized I had a router issue discussed in another post - no wireless to wireless connectivity allowed)
2. Look up Gyro/Accel part I bought and review the library I referenced in the last post that is supposed to do alot for me - found it, its loaded on the ITC card, just have to review it, DONE
3. Integrate library into my current code base as an add-on option (not a replacement for existing code - in case helps for naught) - DONE, now I have to test the first cut
4. Create wiring harness for new board so it becomes an easy replacement for the existing accelerometer board - DONE
5. Test with Xbox before closing it all up. - DONE, it needs quite a bit of calibration but is now working as I expected.
6. Place into gun and close it up
7. Reanimate the test program on the mac I wrote for plotting position movements of the gun - test this before worrying about xbox - DONE
Xbox:
1. Clean out old xbox and do the 3ROD heat gun fix to get it running again. - DONE
2. Hook it up and get COD running as a test platform again - DONE
3. Test with COD - DONE
1. Order 40mm fan and parts for controller board - I ordered it from Mouser on 8/23/15 - received, waiting time to do something with it.
2. Recalibrate bed so it is level
3. Order wing nuts for bed so its easier to calibrate - ordered & received, not yet installed
ITC:
1. Get gun connected to the network again - SOLVED - (initially only partially, had to direct connect due to wireless inter-connectivity issues. but ultimately I realized I had a router issue discussed in another post - no wireless to wireless connectivity allowed)
2. Look up Gyro/Accel part I bought and review the library I referenced in the last post that is supposed to do alot for me - found it, its loaded on the ITC card, just have to review it, DONE
3. Integrate library into my current code base as an add-on option (not a replacement for existing code - in case helps for naught) - DONE, now I have to test the first cut
4. Create wiring harness for new board so it becomes an easy replacement for the existing accelerometer board - DONE
5. Test with Xbox before closing it all up. - DONE, it needs quite a bit of calibration but is now working as I expected.
6. Place into gun and close it up
7. Reanimate the test program on the mac I wrote for plotting position movements of the gun - test this before worrying about xbox - DONE
Xbox:
1. Clean out old xbox and do the 3ROD heat gun fix to get it running again. - DONE
2. Hook it up and get COD running as a test platform again - DONE
3. Test with COD - DONE